quick release. If you are uncertain about any aspect of the
assembly and adjustment of your bicycle, seek help from
a qualied mechanic or the Currie Tech Customer Service
Department at (800) 377-4532.
WARNING: If you are unsure about the brake set-up and
adjustment procedure, please take your eFlow bicycle
to your selling dealer, or any qualied bicycle mechanic,
and ask for assistance in adjusting the brakes. Improperly
adjusted brakes may cause reduced braking performance,
leading to an accident that could result in serious injury or
death, and property damage. DO NOT ride your bicycle if
you are not condent that the brakes are working properly.
• Removing the rear wheel:
o Removing the rear wheel of an electric bike
is similar to the procedures used to remove
a rear wheel from a conventional bike, with
one exception. On an electric bike, you must
disconnect the motor from the bike’s electrical
system. To do this, locate the motor connector.
The motor connector and associated cables are
zip-tied to the underside of the left chain stay. (See
photo below.)
o Clip the zip tie holding the motor power cable to
the frame.
p. 47/52
To Next Page
Loading...