Charging Instructions
WARNING: Use only the battery charger supplied with this
battery. If you use any other battery charger, you will void the
warranty, you may damage the battery and you could cause a
re that would result in property damage and possible injury or
death.
The Battery supplied with your eFlow can be charged either
while it is installed in the bike, or removed from the bike.
Charging the battery outside of the bike can be convenient
if there is not access to a 110-volt outlet near where you
parked your bike. Instructions for both charging options are
below. In either case, the following instructions are relevant:
• Check the Voltage Selector switch on the charger to
ensure that it is set to your local line voltage (110 volts for
the United States).
• Plug the charger into the wall outlet.
• Ensure that the charger switch is OFF before connecting
the charger to the battery.
To charge the battery while it is installed in the bike:
• Locate the charger port on the left side of the bike frame,
just above the bottom bracket; rotate the charger port
cover on the side of the battery housing clockwise or
counter clockwise to expose the charger receptacle.
(See below.)
Currie Tech Technical and Customer Service: +1 800-377-4532
p. 40/52
To Next Page
Loading...