Damage in Transit
The battery and charger should be tested when received.
If the battery or charger is damaged in any way, a claim should
be led with the carrier. A full report of the damage should
be obtained by the claim agent, and this report should be
forwarded to Currie Tech. Currie Tech will advise the disposition
to be made of the equipment and arrange for repair or
replacement.
IX. Troubleshooting
We have engineered your eFlow bicycle to be a safe and
reliable transportation vehicle. However, from time-to-time,
things can go wrong. The following is intended to be a general
guide for diagnosing and remedying simple issues that may
happen. If you are unsuccessful in resolving a problem, please
do not hesitate to contact your selling dealer or the Customer
Service Team at Currie Tech at 1-800-377-4532.
Problem: Bicycle does not turn on
Cause #1: Dead battery
Solution #1: Recharge the battery (Please see the
instruction for proper charging of the battery
in Section VIII and/or in the Instruction Manual
supplied with the battery.
Cause #2: The battery is improperly installed on the
bicycle.
Solution #2: Check that the battery is securely plugged
into the battery receptacle. (Please refer to
page 23.)
p. 45/52
To Next Page
Loading...