from the three included, press rmly between the metal cup
and the nylon spacer (see ‘F’). Slide spacer back over the
bottom of the assembly (see ‘G’) and repeat steps ‘B’-‘D’. If
handle continues to be in an undesirable position, remove
the assembly from the bicycle and repeat steps ‘E’-‘H’ and
‘B’-‘D’ until both handles are in optimal positions using the
remaining washers
CAUTION: This product should be installed only on bicycles
with inherent factory installed safety devices for wheel
retention such as no turn washers; lipped dropouts or hooked
washers that t into eyelets in the bicycle’s front fork. Carefully
follow the installation instructions and tests prior to use.
Improper installation could result in wheel/frame separation
and cause serious bodily injury. This product should only be
operated by a person 14 years of age or older under adult
supervision in order to ensure proper installation has occurred.
MAINTENANCE: Keep clean, dry, and lightly lubricate all
moving parts.
(Instructions reproduced with permission from Coombs
Cycling Technologies LLC, 520 North Main, Ste 304
Heber City, UT, 84032-USA)
Currie Tech Technical and Customer Service: +1 800-377-4532
p. 50/52
To Next Page
Loading...