Each “bar” on the battery gauge represents 20% of the
battery’s full charge. The gauge should show the battery
level within a few moments of turning on.
If the gauge still shows completely empty after a few
seconds, check all connections to the controller and
display, and re-connect.
You may also need to begin riding the bike before the
battery “wakes up” fully and begins sending the charge
signal to the display.
Understanding the battery gauge
“F” Illuminates when
the battery is nearly full.
The cell diagram
indicates the charge
level of the main battery.
“E” Illuminates
when battery is
nearly empty.
The down arrow Illuminates
while braking, indicating
that regen mode is active.
The up arrow Illuminates
while the motor is being
powered.
Regenerative braking is automatically activated when the
brake lever is held, even if only partially. This feature slowly
pushes energy back into the bike’s battery, which can
extend overall riding range if used frequently.
Currie Tech Technical and Customer Service: +1 800-377-4532
p. 32/52
To Next Page
Loading...