EG4 BRIGHTMOUNT User Manual

EG4 ELECTRONICS | INSTALLATION GUIDE
INSTALLATION
A) Leg Group
Assembly
Use M8*80 bolts, M8
spring washers, flat
washers, and M8 nuts to
install the U connectors as
shown in the illustration to
the right.
4
www.eg4electronics.com
Version 1.0.0 | Specifications subject to change without notice.
© 2023 EG4 Electronics, LLC. All rights reserved.
The adjustable leg is used to change the angle of the array.
Adjustment instructions are on the following page.
Use M8*65 bolts, M8
spring washers, flat
washers, and M8 nuts to
install the mount group as
shown in the illustration
to the left.

EG4 BRIGHTMOUNT Specifications

General

Brand	EG4
Model	BRIGHTMOUNT
Category	Racks & Stands
Language	English