Eggtimer Quasar Quick Start Guide
Power: 7.4v/2S LiPo, 500 mAH or higher recommended. Bigger mAH’s is Better…
Outputs:
Drogue: Connect to DROG terminals
Main: Connect to MAIN terminals
AUX: For airstarts, etc…
See Appendix C for use with servos
WiFi Connection
Select the “Quasar_xxxxx” SSID (or your custom SSID if you set one), and use the
passkey that was on the WiFi module’s envelope (you did save it, right?), or recover the
passkey using the data cable (see Appendix E for instructions)
Set your browser to 192.168.4.1 to open the Status Page…bookmark it for later use!
If asked, tell your device to “keep the connection” even though there’s no Internet
Status Page
Displays:
SSID and Software Version
Radio Regulatory Domain
Status (Disarmed, normally)
Validation Code (for arming)
Arming Button
Drogue Settings
Main Settings
AUX Settings
GPS Status
GPS Coordinates
Battery Voltage/Percentage
ASL altitude
Temperature in F
Drogue Settings
Click on Change link next to Drogue settings to change
Delay: OFF, 0.1-9.0 secs by 0.1 secs, 3-30 secs by 1 sec.
Descent Samples/sec
Drogue mode (igniter/servo)
To Next Page
Loading...