Drogue on-time or servo direction/skew
Main Settings
Deployment Altitude:
OFF, Nose-Over, 50’-500’ by 50’, 500’-3,000’ by 100’
Main Mode (igniter/servo)
Main on-time or servo direction/skew
FailSafe:
Velocity: OFF, 50-200 ft/sec by 25 ft/sec
Time: 50-3000 ms by 25 ms
Global Settings
Click on the Settings link on the Status Page to change:
LDA – Launch Detect Altitude
Launch samples/sec
Auto-Arm (OFF/ON)
Name (sent out telemetry port with other data,
use your Ham call sign if you’re using the 70cm Ham version)
Link to Hardware Setup Menu
Hardware Setup Menu
Voltage Offset: Reported Voltage – Actual Battery Voltage (0.0-0.9v)
Tone: Buzzer pitch (Low, Medium, High)
Frequency/ID display, with Change link
SSID: Custom WiFi SSID (A-Z,a-z,0-9, and underscore), 8-14 characters
Power-cycle your Quasar to apply the new SSID
Arming
Remote Arming:
Select the proper flight settings
Verify that all enabled outputs are ON or greyed out (n/a)
Enter the 4-digit validation code, then click ARM
When the “Armed” page displays, CLOSE YOUR BROWSER
It wouldn’t hurt to turn off your device’s WiFi, either.
Auto-Arm:
Quasar will arm itself 60 seconds after power-on, if channels pass continuity check
Disarming (for aborted flight)
Connect to the Status page (192.168.4.1) (this may take several seconds)
Enter the 4-digit validation code, then click DISARM
Wait for the normal Status Page… if it takes more than 10 seconds, refresh your browser
To Next Page
Loading...