EasyManua.ls Logo

EGL A11 - Page 22

Default Icon
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STARTING PROCEDURE (KICK START)STARTING PROCEDURE (KICK START)
Starting When the Engine Is ColdStarting When the Engine Is Cold
1. Turn the key switch to the “ON” position.
2. Make sure the transmission is in the neutral position.
3. Turn the fuel tap to the “ON” position.
4. Pull and hold the choke lever (depending on your model).
5. Li the choke lever up.
6. Press and hold the brake lever on the right side of the handle bar.
7. Open the throttle no more than 1/4 of the way.
8. Open the kick start lever and from the top of the kick starter stroke, kick through to the bottom with a
rapid continuous motion.
9. Aer about 1 minute aer the engine starts, release the choke lever(depending on your model).
10. Aer about 1 minute aer the engine starts, push the choke lever down.
11. Wait until the engine warms up for approximately 2-4 minutes. Aer the 2-4 minutes warm up, you are
ready to go.
Starting When the Engine Is WarmStarting When the Engine Is Warm
1. Repeat steps 1, 2, 3, 6, 7, and 8 in section “Starting when the engine is cold1. Repeat steps 1, 2, 3, 6, 7, and 8 in section “Starting when the engine is cold
BASIC OPERATING & RIDINGBASIC OPERATING & RIDING
FLOODED ENGINEFLOODED ENGINE
If the engine fails to start aer repeated attempts, it may be ooded with excess fuel. Follow the steps below to If the engine fails to start aer repeated attempts, it may be ooded with excess fuel. Follow the steps below to
clear a ooded engine.clear a ooded engine.
1. Press the engine stop switch and hold it.
2. Open the throttle completely.
3. Press the engine start switch and hold it for 5 seconds. (Electric Start)
4. Kick start the engine several times. (Kick Start)
5. If necessary, remove the spark plug and let it dry.
6. Once the engine starts, open the throttle¼ for a few times.
STOPPING ENGINESTOPPING ENGINE
To stop the engine, shi into neutral and push the engine stop switch To stop the engine, shi into neutral and push the engine stop switch (A)(A) on the le side of the handle bar. on the le side of the handle bar.
DO NOT ride your motorcycle with full load and DO NOT rev
up the engine when cold. Since the piston warms up and ex-
pands faster than the liquid cooled cylinder, this might cause
engine damage. Always let the engine idle until warm or ride it
warm at low RPM speeds.
CAUTION
!
For your safety, avoid starting or operating the motorcycle
in an enclosed area with poor ventilation, such as a garage.
The motorcycle’s exhaust gas contains poisonous carbon
monoxide which can collect rapidly in an enclosed area and
result in illness or death.
CAUTION
!

Related product manuals