Need help?Do you have a question about the Egnater Rebel-20 and is the answer not in the manual?
General| Power Output | 20 watts |
|---|---|
| Power Tubes | 2 x EL84 |
| Preamp Tubes | 3 x 12AX7 |
| Channels | 1 |
| EQ | Bass, Middle, Treble |
| Master Volume | Yes |
| Effects Loop | Yes |
| Type | Tube |
| Reverb | No |
| Footswitch Included | No |
| Controls | Gain, Bass, Middle, Treble, Master Volume |
| Speaker Output | 4 Ohm, 8 Ohm, 16 Ohm |
| Footswitchable | Channel Select, Gain Boost (with optional footswitch) |
Details the physical layout of tubes and components on the chassis.
Details AC inlet, fuse, and AC voltage selection for proper operation.
Explains how to connect speakers based on impedance (Ohms).
Describes the series effects loop and its usage with external effects units.
Details the 3-year warranty for amplifiers, combos, and cabinets.
Covers the 90-day warranty specifically for tubes.
Outlines the process for returning defective products for repair or replacement.
Provides contact information and support hours for warranty inquiries.
To Next Page
