EDGER ATTACHMENT — EA0800 13
TROUBLE SHOOTING
PROBLEM
CAUSE SOLUTION
Motor fails to start.
◾ The battery pack is not attached to the
power head.
◾ Attach the battery pack to the power
head.
◾ No electrical contact between the power
head and the battery pack.
◾ Remove the battery, check contacts
and reinstall the battery pack until it
snaps into place.
◾ The battery pack is depleted. ◾ Charge the battery pack with EGO
chargers listed in this manual.
◾ The lock-off button and trigger are not
depressed simultaneously.
◾ Press down the lock-off button and
hold it, then depress the trigger to turn
on the power head.
Power head stops
during operation.
◾ The motor is overloaded. ◾ The motor will recover when the load
is removed. For continuous working,
decrease the load of the power head.
◾ The battery pack or the power head is
too hot.
◾ Allow the battery pack or power head
to cool until the temperature drops
below 67°C.
◾ The battery pack is disconnected from
the tool.
◾ Re-install the battery pack.
◾ The battery pack is depleted. ◾ Charge the battery pack with EGO
chargers listed in this manual.
Uneven edge
◾ Grass or soil edged is too wet. ◾ Avoid edging in wet soil or wet grass.
◾ Blade guard is clogged. ◾ Stop the motor, remove the battery
pack, and remove debris from the
blade guard.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
To Next Page
Loading...