Ego Power+ T6 - Page 38

38 56-VOLT LITHIUM-ION ELECTRIC LAWN TRACTOR — TR4200E
LCD
Display
Description
Tractor
Status
Indicator
Audio
Indicator
Cause Solution
The alert icon blinks
Flashes
red
One beep
The blade motor is overloaded.
Raise the deck cutting height or slow the
driving speed to reduce the load of the
tractor.
The side discharge chute is
clogged with grass and debris.
Clean the side discharge chute after each
use.
There is an interference
between the blade and the
tractor deck.
Call EGO Customer Service Centre
The icons of each
occupied battery
compartment and alert
icon blink every 1 second
at the same time on the
LCD screen.
Flashes
red
Keeps
beeping
until the
PTO switch
is pushed
downward.
The battery packs are low on
charge and the tractor is in
Limp Home mode.
Stop working and return to the battery
charging area.
NOTE: When the tractor is in Limp-Home
mode, the blades are automatically switched
into low rotation speed and meanwhile
the audio indicator will keep beeping.
The operator should push the PTO switch
downward to turn off the blade motors. The
audio indicator will stop beeping after the
blades stop.
The icon of each
occupied battery
compartment and alert
icon blink every half a
second.
Flashes
red
Keeps
beeping
The blade motor was
interrupted in operation and
the PTO switch is not set to off
position.
The tractor will stop working immediately.
The operator should transport the tractor to
the battery charging area for charging.
CCS icon illuminates on
the LCD screen
Solid
green
No
The tractor continues forward
at a set speed without needing
to step on the accelerator
pedal.
This is normal operation. If needed, turn
the CCS function off following the section
“Tostop (exit) Cruise Control (CCS)” in the
manual.
CCS icon blinks on the
LCD screen.
OFF No
The CCS (cruise control
system) function has failed.
The CCS function could not be set when
the tractor is driving at very low speed or is
driving in reverse.
Parking-brake pedal is
depressed to stop the tractor.
After the parking-brake pedal is released,
press the CCS button and the CCS icon
will illuminate on the LCD, or exit the CCS
function following the instructions in the
section “To stop (exit) Cruise Control
(CCS)”.
n/a n/a OFF
Keeps
beeping
The tractor is parked on a
slope and the operator leaves
the tractor without setting the
parking-brake pedal at the
parking-brake position.
Set the parking-brake pedal at the parking-
brake position. The parking-brake icon will
illuminate and the sound indicator will stop
beeping.
OFF Charging Port Fault
Solid RED n/a There is no power supply.
Check the wall outlet whether there is
220 V-240 V supplied or the socket is good.
Solid RED n/a
Electronic faults, such as the
charging port is in open circuit,
the fuse is blown, etc.
Contact EGO customer service centre for
repair.