56 VOLT LITHIUM-ION REAR MOTOR BIKE-HANDLE BRUSHCUTTER — BC3800E
17
TROUBLESHOOTING
PROBLEM
CAUSE SOLUTION SOLUTION
Fail to start.
◾ The battery pack is not attached to the
brushcutter.
◾ Attach the battery pack to the power
head.
◾ No electrical contact between the
brushcutter and the battery pack.
◾ Remove battery, check contacts
and reinstall the battery pack until it
snaps into place.
◾ The battery pack is depleted. ◾ Charge the battery pack with EGO
chargers listed in this manual.
◾ The lock-off lever and trigger are not
depressed simultaneously.
◾ Press down the lock-off lever and
hold it, then depress the trigger to
turn on the brushcutter.
Stop working.
◾ The motor is overloaded. ◾ The motor will recover when the
load is removed. For continuous
working, decrease the load on the
power head.
◾ Heavy cutting line is used. ◾ Use standard nylon cutting line with
diameter no more than 2.4mm.
◾ The battery pack or the brushcutter is too
hot.
◾ Allow the battery pack or the power
head to cool until the temperature
drops below 67°C.
◾ The battery pack is disconnected from the
tool.
◾ Re-install the battery pack.
◾ The battery pack is depleted. ◾ Charge the battery pack with EGO
chargers listed in this manual.
Trimmer head will not
advance line (only
using with trimmer
head).
◾ The motor shaft or trimmer head is bound
with grass.
◾ Stop the machine, remove the
battery and remove the grass from
the motor shaft and trimmer head.
◾ There is not enough line on the spool. ◾ Remove the battery and replace the
cutting line, follow the section “LINE
REPLACEMENT” in this manual.
◾ The trimmer head is dirty. ◾ Remove the battery and clean the
spool, spool retainer and spool base.
◾ Line is tangled on spool. ◾ Remove the battery, remove the line
from the spool and rewind, follow
the section “LINE REPLACEMENT” in
this manual.
◾ The line is too short. ◾ Remove the battery and pull the
lines while alternately pressing
down on and releasing the bumb
knob.
To Next Page
Loading...
Need help?
General
