To Next Page

To Previous Page

BRUSH CUTTER ATTACHMENT — BCA1220/BCA1220-FC24

NOTE: You can skip steps 3 and 4 if the

front handle is already mounted on the

power head shaft.

3. Push the front handle onto the shaft

within the mounting zone between

the threshold ring and the coupler

on the power head shaft (Fig. 11b).

4. Insert the clamping block into the

handle slot (Fig. 11c).

5. Align the groove on the barrier bar

with the corresponding one on the

front handle; hold the bar onto the

front handle; mount the NEW quick-

release lever and tighten the wing

nut. Make sure that the front handle

is positioned upwards and points

toward the top of the rear handle

(Fig. 11d).

11c

Clamping Block

11d

New Quick-release Lever

Wing Nut

11b

Front Handle

Coupler

Threshold Ring

Questions and Answers:

Need help?

Do you have a question about the EGO BCA1220 and is the answer not in the manual?

EGO BCA1220 Specifications

General