BRUSH CUTTER ATTACHMENT — BCA1220/BCA1220-FC32
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Brush cutter fails
to start.
◾
The battery pack is not
attached to the power
head.
◾
No electrical contact
between the power
head and the battery
pack.
◾
The battery pack charge
is depleted.
◾
The lock-off lever
and trigger are
not depressed
simultaneously.
◾
Attach the battery pack to the power
head.
◾
Remove battery, check contacts and
reinstall the battery pack until it snaps
into place.
◾
Charge the battery pack with EGO
chargers listed in this manual.
◾
Follow the section “STARTING/
STOPPING THE POWER HEAD” in the
manual for PH1400/PH1400-FC/PH1420/
PH1420-FC.
Brush cutter stops
while cutting.
◾
The motor is overloaded.
◾
The motor will recover when the load
is removed. For continuous working,
decrease the load on the power head.
◾
The battery pack or the
power head is too hot.
◾
Allow the battery pack or the power head
to cool until the temperature drops below
153 °F (67 °C).
◾
The battery pack is
disconnected from the
machine.
◾
Re-install the battery pack.
◾
The battery pack charge
is depleted.
◾
Charge the battery pack with EGO
chargers listed in this manual.
To Next Page
Loading...
Need help?
General
