OPERATION
WARNING: Do not allow familiarity with this product
to make you careless. Remember that a careless fraction
of a second is sufcient to inict serious injury.
WARNING: Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING: Always remove the battery pack from
the product when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing the
battery pack will prevent accidental starting that could
cause serious personal injury.
Before each use, inspect the entire product for damaged,
missing, or loose parts, such as screws, nuts, bolts,
caps,etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced.
APPLICATION
You may use this product for the purposes listed below:
◾ Clearing hard surfaces such as driveways and
walkways.
◾ Keeping decks and driveways free from leaves and
pine needles.
NOTICE: The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse.
INSTALLING/REMOVING THE BATTERY PACK
CHARGE BEFORE FIRST USE.
NOTICE:
For best performance, we recommend use of
the EGO 56V Battery BA2240E (4.0 Ah) or any EGO 56V
battery with higher capacity.
◾ To Install (Fig. H)
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a “click”.
◾ To Remove (Fig. I)
Depress the battery-release button and pull the battery
pack out.
WARNING: Always take care to note the location of
your feet, children, or pets when pressing the battery-
release button. Serious injury could result if the battery
pack falls. NEVER remove the battery pack when in a high
location.
POSITIONING THE BACKPACK BLOWER
WARNING: Dress properly to reduce the risk of
injury when operating this tool. Do not wear loose clothing
or jewelry. Wear eye and ear/hearing protection. Wear
heavy, long pants, boots and gloves. Do not wear short
pants or sandals or go barefoot.
To Adjust The Support Harness
1. Put your arms through the backpack straps to support
the blower on your back.
2. Temporarily adjust both shoulder straps to comfort-
able positions (Fig. J), making sure that your elbow is
comfortable.
3. Snap the chest buckle and adjust its length if neces-
sary (Fig. K).
4. Snap the waist buckle and adjust its length so that the
backpack is securely supported by your hips
(Fig. L & M).
NOTICE: The backpack shouldn’t sit too high on your
back; it should be positioned closer to your hips than to
your shoulders.
5. Readjust the shoulder straps for security and comfort.
Makes sure that the backpack sits securely on your
back, with the weight supported by the waist strap,
and without excess movement when you move (Fig. N).
6. Insert any extra length of belt around the waist into the
elastic on both sides (Fig. O).
7. To detach the tool from your back, just press the waist
and chest buckles to release them and lower the tool
(Fig. P).
To Adjust The Control Handle
1. Loosen the wing nut to adjust the handle forward or
backward as needed (Fig. Q & R) and then tighten the
wing nut to secure the position of the handle.
2. You may also rotate the handle as needed for comfort
(Fig. S).
3. To enlarge the area you are cleaning, move the tube to
the left or the right (Fig. T).
STARTING/STOPPING THE BLOWER (Fig. U)
1. To start the blower, press down on the lock-off lever
and hold it, then depress the trigger. The blower will
begin to run.
2. To stop the blower, release the trigger.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
