To Next Page

To Previous Page

56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP/LM2100SP-FC/LM2100/LM2100-FC 35

CLEANING THE MOWER

WARNING:

Always remove the battery pack when servicing or transporting the

mower.

The underside of mower deck should be cleaned after each use, as grass clippings,

leaves, dirt and other debris will accumulate. This accumulation is undesirable, as it will

promote rust and corrosion.

Remove any build-up of grass and leaves on or around the drive shaft (only LM2100SP/

LM2100SP-FC) and motor fan (do not use water). Wipe the mower clean with a damp

cloth.

REMOVING THE BLADE

WARNING:

Always protect your hands by wearing heavy gloves or wrapping

the cutting edges with rags or other materials when performing any maintenance on

the mower blade. Always remove the battery pack when servicing or transporting the

mower.

NOTICE: The following tools are required for replacing the blade:

◾

9/16” (14mm) wrench

◾

torque wrench

◾

Manual screwdriver or metal rod with

a diameter of 5/16” (8mm)

◾

Manual screwdriver or metal rod with

a diameter 1/4” of (6.35mm) or less.

1. Stop the motor; remove the battery

pack from the mower.

2. Turn the mower on its side.

3. While wearing protective gloves,

place a metal rod (e.g., a 3.5”

length screw bit) with diameter less

than 5/16” (8mm) into the xing hole to act as a stabilizer (Fig. 22).

4. Use a 9/16 inch (14mm) wrench to turn the blade bolt counterclockwise to loosen it.

THIS SIDE FACING GRASS

Stabilizer

Loosen

Questions and Answers:

Need help?

Do you have a question about the EGO LM2100 and is the answer not in the manual?

EGO LM2100 Specifications

General