◾ DO NOT attempt to clear clogs from the unit without
first removing the battery.
◾ Keep the blower and its handle dry, clean and free
from oil and grease. Always use a clean cloth when
cleaning. Never use brake fluids, gasoline, petroleum-
based products, or any strong solvents to clean your
blower. Following this rule will reduce the risk of loss of
control and deterioration of the enclosure plastic.
◾ Batteries can explode in the presence of a source
of ignition, such as a pilot light. To reduce the risk of
serious personal injury, never use any cordless product
in the presence of an open flame. An exploded battery
can propel debris and chemicals. If exposed, flush with
water immediately.
◾ Never run the unit without the proper equipment
attached. Always ensure that the blower tube is installed.
◾ Never use the blower near res or hot ashes. Use
near fires or ashes can spread fires and result in
serious injury and/or property damage.
◾ Never use blower to spread chemicals, fertilizers,
or any other toxic substances. Spreading these
substances could result in serious injury to the operator or
bystanders.
◾ Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If you
loan this tool to someone else, also loan these instructions
to them to prevent misuse of the product and possible
injury.
SAVE THESE INSTRUCTIONS!
SPECIFICATIONS
Voltage
56V
Maximum Air Volume
1014m
3
/h
Maximum Air
Velocity
Without Nozzle 65.4m/s
With Round Nozzle 75m/s
With Flat Nozzle 63.3m/s
Approx. Run Time
(with EGO BAX1500
backpack battery)
Boost 70min
Level 4 100min
Level 3 140min
Level 2 210min
Level 1 340min
Maximum Blower Force 19.2N
Blower Weight 2.7kg
Measured sound
power level L
WA
Without Nozzle
94.4 dB(A)
K=1.1 dB(A)
With Round Nozzle
91.0 dB(A)
K=2.2 dB(A)
With Flat Nozzle
89.6 dB(A)
K=2.4 dB(A)
Sound pressure
level at operator’s
ear L
PA
Without Nozzle
84.5 dB(A)
K=3 dB(A)
With Round Nozzle
81.5 dB(A)
K=3 dB(A)
With Flat Nozzle
80.2 dB(A)
K=3 dB(A)
Guaranteed sound power level L
WA
(according to 2000/14/EC)
95 dB(A)
Vibration a
h
1.167 m/s²
K=1.5 m/s
2
◾ The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another.
◾ The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE: The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should
wear gloves and ear protectors in the actual conditions
of use.
To Next Page
Loading...
Need help?
General
