RECOMMENDED ACCESSORIES
PART NAME PART NUMBER
Round nozzle AN6000R
Flat nozzle AN6000F
PACKING LIST
PART NAME QUANTITY
Blower 1
Blower tube 1
Spread nozzle 2
Operator’s manual 1
DESCRIPTION
KNOW YOUR BLOWER (Fig. A)
1. Socket
2. Air-speed trigger
3. Boost Button
4. Lock Button
5. Blower Tube
6. Tube-release Button
7. Hook
8. Round Nozzle
9. Flat Nozzle
10. LED #1
11. LED #2
12. LED #3
13. LED #4
OPERATION
WARNING: Do not allow familiarity with this product
to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING: Do not attempt to modify this product
or create accessories not recommended for use with this
blower. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
WARNING: It is not recommended to use the blower
at a high speed for a long time, as large vibration and
noise may be harmful to your health.
WARNING: Always remove the battery pack from
the product when you are doing maintenance or when not
in use. Removing the battery pack will prevent accidental
starting that could cause personal injury.
Before each use, inspect the entire product for damaged,
missing, or loose parts, such as screws, nuts, bolts,
caps,etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced.
ASSEMBLING/REMOVING THE BLOWER TUBE
◾ To Assemble (Fig. B)
Align the groove and push the tube onto the blower
housing until you hear a “click”.
◾ To Remove (Fig. C)
Press the tube-release button and pull the tube out.
ASSEMBLING/REMOVING THE BLOWER ROUND/
FLAT NOZZLE
◾ To Assemble(Fig. D)
Align the groove in the round/flat nozzle with the tube
knob and push the nozzle onto the tube until it snaps
into place.
◾ To Remove(Fig. E)
Press and hold the nozzle-release button to disengage
the latch, then pull the nozzle straight from the blower.
INSTALLING/REMOVING THE BATTERY PACK
NOTE:
For best performance, we recommend use of the
EGO 56V Battery BAX1500 backpack battery.
Charge before rst use.
◾ To Install (Fig. F)
Put on the backpack battery and insert the battery plug
into the blower.
◾ To Remove (Fig. G)
Pull the battery plug out.
WARNING: Never drag the cord to remove the
battery pack from the blower.
STARTING/STOPPING THE BLOWER (Fig. H)
◾ To Start
Before running the blower, please check and confirm the
lock button is in position “On”. If not, push the lock button
to position “On” , otherwise the air-speed trigger can’t be
depressed to start the blower.
Depress the air-speed trigger to turn on the blower.
Increased pressure on the trigger results in higher
blowing speed.
To Next Page
Loading...
Need help?
General
