56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC 19
3. Align the grooves in the battery
pack with the raised ribs in one
of the battery compartments, and
then insert the battery pack into the
compartment (Fig.11).
4. Push the battery pack until you hear
a “click”. The battery-release button
will spring up when the battery pack
is securely attached.
5. Attach the other battery pack into
the other battery compartment in the
same way.
6. To detach the battery pack, depress
the battery-release button to release
the battery pack, and then lift it out of
the compartment (Fig. 12).
7. Close the battery cover.
NOTICE: Make sure that the latch on the snow blower snaps into place and that the
battery pack(s) are secured to the unit before starting operation.
STARTING/STOPPING THE SNOW BLOWER
CAUTION:
Do not attempt to override the operation of the safety button. Do not
rapidly turn the snow blower off and on.
WARNING:
The operation of a snow blower can result in foreign objects being
thrown into your or others’ eyes, which can damage eyes severely. Always wear safety
glasses while operating the snow blower or while performing any adjustments or repairs
on the snow blower.
WARNING:
Ensure that other people and pets remain at least 100’ (30m) away from
the snow blower when it is in use.
WARNING:
The auger will continue to rotate for a few seconds after the snow
blower is turned off. Allow the auger to stop rotating before starting it again.
Install
Battery
11
2
1
Remove
Battery
12
Battery-
Release
Button
To Next Page
Loading...
Need help?
General
