To Next Page

To Previous Page

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC20

To Start the Snow Blower

1. Ensure that the handle assembly is securely adjusted to appropriate height, the

side-discharge chute assembly is mounted properly, and the chute and chute

deector are adjusted to an appropriate position.

2. Attach the battery pack(s) to the snow blower and close the battery cover.

NOTICE: Make sure that the latch on the snow blower snaps into place and that the

battery pack(s) are secured to the snow blower before operation.

3. Press the safety button and hold for

1 second, and the LED indicator will

blink green. Press the auger-switch

trigger to turn on the snow blower

while the LED indicator blinks

(Fig.13).

NOTICE: The snow blower can be

turned on by the auger-switch-trigger only

when the LED indicator blinks.

NOTICE: The snow blower may not properly start if its battery temperature is -4°F

(-20°C) or less. If the snow blower doesn’t start, remove the battery from the snow

blower and allow it to warm indoors for 10 minutes or longer. Reinstall the battery and

try again.

To Stop the Snow Blower

1. Fully release the auger-switch trigger.

2. The electric brake in the Automatic Braking Mechanism will stop the auger

rotation within 3 seconds of the auger-switch release.

Variable-Auger-Speed System (Fig. 13)

The speed of the auger can be adjusted to control the throwing distance.

1. To increase the speed, push the auger-speed-control lever forwards.

2. To decrease the speed, pull the auger-speed-control lever backwards.

Auger-Switch Trigger

Auger-Speed-Control Lever

Safety Button

Other manuals for EGO SNT2400

Questions and Answers:

Need help?

Do you have a question about the EGO SNT2400 and is the answer not in the manual?

General