56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC26
If the snow blower is over-heating itself, the LED indicator on the snow blower will ash
orange and the battery indicator will be OFF.
When batteries are overheating, release all the triggers, wait until the overheated battery
pack(s) cool down or change the new battery pack(s), then restart the snow blower. To
prevent shut off due to battery high-temperature protection, don’t try to use a single
battery to power the snow blower when the depth of the accumulated snow exceeds
8 inches or when the snow is very wet or icy. We recommend the use of two batteries
working simultaneously. This is helpful in attaining the peak power of the snow blower.
After high-temperature protection has occurred, slow down your pace and narrow width
of the clearing swath to reduce the load on the battery.
OPERATING TIPS
DANGER
:
Never use a snow blower on frozen lakes, rivers, or similar surfaces.
Death or serious injury could occur if the ice breaks.
DANGER
:
Never use the snow blower on a rooftop or other unstable surface,
which can result in death or serious personal injury.
WARNING:
Do not use snow blower on ice, which can cause the operator to slip
and fall, resulting in possibly serious personal injury.
WARNING:
Do not wear loose clothing, scarves, or jewelry. They can be caught
in moving parts and cause death or serious personal injury.
WARNING:
Keep all snow discharge pointed away from all electrical devices to
reduce the risk of electrocution or electric shock.
WARNING:
Never point the snow blower or discharge chute in the direction of
people or pets. Thrown snow or other objects can cause serious personal injuries.
WARNING:
Make sure that the area to be cleared is free of stones, sticks, wires,
gravel, and other objects that could be accidentally thrown by the snow blower in any
direction and cause serious personal injury to the operator and others.
◾
If the unit comes in contact with any type of obstruction or debris during use, stop
the snow blower, remove the battery pack(s), remove the obstruction, and inspect
the unit carefully for damage before proceeding.
To Next Page
Loading...
Need help?
General
