56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC 25
CLEARING A CLOGGED CHUTE
WARNING:
Hands coming in
contact with the rotating auger inside the
chute is the most common cause of injury
associated with snow blowers. Never use
your hand to clean out the chute.
WARNING:
Never reach into the
discharge chute or place any body part in
front of the snow blower when the unit is
operating or when the battery pack(s) are
installed. Always ensure all moving parts
have stopped and the battery pack(s) have
been removed before clearing any obstructions. Failure to follow these instructions can
result in serious personal injury.
To Clear the Chute:
1. Shut the motor off!
2. Remove the battery pack(s) from the snow blower.
3. Wait 10 seconds to be sure the auger has stopped rotating.
4. Always use the chute clean tool which is attached to the machine as an
accessory. DO NOT USE YOUR HAND (Fig.20).
BATTERY HIGH-TEMPERATURE PROTECTION
The battery pack will generate heat during operation. If the battery temperature exceeds
158°F (70°C) during operation, the protection circuit will immediately turn off the snow
blower to protect the battery pack from heat damage. The snow blower LED indicator will
turn off and the LED on the battery will ash orange or shine red.
NOTICE: The LED on following battery packs will ash orange lights when overheated:
BA1120, BA1120-FC, BA1400, BA1400-FC, BA2240, BA2240-FC, BA2800, BA2800-FC,
BA4200 and BA4200-FC; the LEDs on following battery packs will shine red lights when
overheated: BA1400T, BA1400T-FC, BA2800T, BA2800T-FC, BA4200T, BA4200T-FC,
BA5600T and BA5600T-FC.
20
Chute Clean Tool
To Next Page
Loading...
Need help?
General
