56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC24
LED INDICATOR MEANING ACTION
Shinning Green
Snow blower is working
properly; each battery has
at least 15% of its charge.
n/a.
Flashing Red
The battery is nearly
depleted.
Stop the snow blower and
charge the battery pack(s).
Flashing Green and
Red alternately
Error
Contact EGO customer service
center
Shinning Orange
The snow blower stops
due to overheating.
Remove the batteries from the
snow blower, move them to the
shade and cool them at least 15
minutes.
Flashing Orange
The snow blower is
overloaded.
First remove the battery pack,
then check and clean if snow
has collected beneath the deck.
Slow down your pace when snow
moving. If this does not work,
please contact EGO customer
service center.
Dark & LED on
battery ashing
Battery overheat (See
section “BATTERY
HIGH-TEMPERATURE
PROTECTION” in this
manual).
Remove the battery from the
snow blower and wait until the
battery pack cools down to
approximately 152°F (67°C), then
reinstall the battery and restart
the snow blower.
SNOW BLOWER OVERLOAD PROTECTION
To prevent overload conditions, do not try to remove too much snow at one time.
Slow down your pace or decrease the width of the snow-clearing swath. Your snow
blower has built-in overload-sensing elements. When the snow blower is overloaded,
the motor will decrease the speed automatically and you will hear the volume of the
motor decrease. Slow down your pace or narrow the clearing width, after which the
motor speed will automatically resume its normal setting. If this remedy does not solve
the overload situation, the sensor will shut off the motor automatically and the LED
indicator on the snow blower will ash orange. Remove the battery pack(s) from the
snow blower,wait 10 seconds, and check to see if there is snow or ice stuck in the
auger and deck. If necessary, follow instrucitons for “CLEARING A CLOGGED CHUTE”.
Reinstall the batteries and restart the snow blower.
To Next Page
Loading...
Need help?
General
