56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2400/SNT2400-FC 29
3. Loosen and remove the 3 screws to
separate the gear from the wheel.
Save the gear for reassembly
(Fig.21).
4. Replace the wheel with a new one.
5. Reassemble the gear, new wheel
and outer gasket in reverse order.
Lock them with the wheel-locking
pin.
MOUNTING AND DETACHING THE
SCRAPER BAR (Fig.22)
1. Remove the batteries from the snow
blower.
2. Lay the snow blower on its side or
any other convenient position for
scraper bar service.
3. Loosen the outer nut on the skid
shoe just enough to allow the inner
connecting plate to freely rotate
around the corresponding screw
inside (step
1
shown).
4. Loosen the connecting plate on the
other side in the same way.
5. Loosen and remove the ve nuts on the bottom of the deck, as well as the ve
screws inside (step
2
shown) and rotate the connecting plate towards the auger
chamber direction (step
3
shown) to thoroughly remove the scraper bar away
from the deck (step
4
shown).
6. Replace the worn scraper bar with a new one.
7. To reassemble, rst insert the new scraper, bar between the connecting plate
and the bottom of the deck. Rotate the connecting plate until the holes in the
connecting plate, the bottom of the deck, and the scraper bar are aligned. With
the ve holes aligned, insert the ve screws into the holes and secure them with
the ve nuts on the back.
8. Securely tighten the outer nut on the skid shoe.
21
Wheel-Locking Pin
Gear
Screw
Outer Gasket
Inner Gasket
Wheel
1
2
2
4
3
22
Scraper Bar
Nut on the skid shoe
Bottom of deck
Connecting Plate
Screw
Nut
To Next Page
Loading...
Need help?
General
