SNOW SHOVEL ATTACHMENT — SSA1200/SSA1200-FC 17
WARNING:
Make sure that the area to be cleared is free of stones, sticks,
wires, gravel, and other objects that could be accidentally thrown by the snow shovel
attachment in any direction and cause serious personal injury to the operator and
others.
When using the snow shovel attachment,
hold the tool with a firm grip with both
hands while in operation (Fig. 3).
◾
Take notice of the direction of
the wind before beginning. When
possible, discharge snow in the
same direction as the wind to
prevent snow from being thrown
back into your face.
◾
Some parts of the snow shovel
attachment can freeze under extreme weather conditions. Do not attempt to
operate the tool with frozen parts.
◾
If the tool contacts with any type of obstruction during operation, stop it and
remove the battery pack. Check the tool carefully before using.
◾
If the snow is too thick and deeper than the clearing depth, it may take more than
one pass to clear.
◾
When finished, allow the tool to run for several minutes to allow all snow to clear
the auger before storing.
TO START/STOP THE TOOL
See “STARTING/STOPPING THE POWER HEAD” section in the operator’s manual for
PH1400/PH1400-FC 56-volt power head.
3
To Next Page
Loading...
Need help?
General