◾ Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in operating
condition. Be aware of possible hazards even when
the tool is not operating. Take care when performing
maintenance or service.
◾ Do not wash with a hose; avoid getting water in motor
and electrical connections.
◾ Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If
you loan this tool to someone else, also loan these
instructions to them to prevent misuse of the product
and possible injury.
◾ Always wear substantial footwear and long trousers
while operating the machine.
◾ Always be sure of the footing on slopes and to walk,
never run.
SAVE THESE INSTRUCTIONS!
SPECIFICATIONS
Voltage
56 V
No-load Speed 5200-6500 /min
Cutting Mechanism Bump Head
Cutting Line Type
AL0802 2.0mm
Nylon twist line
Cutting Width 33 cm
Weight (without battery pack) 2.76 kg
PACKING LIST
PART NAME QUANTITY
Line Trimmer 1
Guard 1
Front-assist Handle Assembly 1
Hex Wrench 1
Screws for Locking Shaft 2
Operator’s Manual 1
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A)
1. Trigger
2. Rear Handle
3. Lock-off Lever
4. Speed Adjustment Switch
5. Soft Sleeve
6. Adjustable Front-assist Handle
7. Trimmer Head (Bump Head)
8. Bump Knob
9. Line-cutting Blade
10. Guard
11. Ejection Mechanism
12. Electric Contacts
13. Latch
14. Battery-release Button
ASSEMBLY
WARNING: If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING: Do not attempt to modify this product or
create accessories not recommended for use with this line
trimmer. Any such alteration or modication is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
WARNING: To prevent accidental starting that could
cause serious personal injury, always remove the battery
pack from the tool when assembling parts.
UNFOLDING THE SHAFT
WARNING: Do not hold the shaft at the joints in
order to avoid pinching your hands or ngers.
WARNING: Do not attempt to start the trimmer
until the shaft has been locked. Unfold the shaft gently,
ensuring the cable inside the shaft, and lock it with two
screws by the supplied wrench (Fig. B & C).
MOUNTING THE GUARD
WARNING: Always wear gloves when mounting or
replacing the guard. Take care of the blade on the guard
and protect your hand from cutting.
WARNING: Never operate the tool without the
guard rmly in place. The guard must always be on the
tool to protect the user! When the guard was xed,
never attempted to remove or adjust the guard, if
replace needed, it shall be performed by a qualied
service technician!
To Next Page
Loading...
Need help?
General
