EGO ST1510E - Warranty

56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1510E 17
EN
PROBLEM CAUSE SOLUTION
Trimmer head will not
advance line
◾ The motor shaft or trimmer head
is bound with grass.
◾ Stop the trimmer, remove the battery, and
remove the grass from the motor shaft and
trimmer head.
◾ There is not enough line in the
spool retainer.
◾ Remove the battery and replace the cutting
line; follow the section “LINE REPLACEMENT”
in this manual.
◾ The trimmer head is dirty. ◾ Remove the battery and clean the spool retainer
and spool base.
◾ Line is tangled in the spool
retainer.
◾ Remove the battery, remove the line from the
spool retainer and rewind; follow the section
“LINE REPLACEMENT” in this manual.
◾ The line is too short. ◾ Remove the battery and pull the lines while
alternately pressing down on and releasing the
trimmer head.
Grass wraps around
trimmer head and
motor housing
◾ Cutting tall grass at ground
level.
◾ Cut tall grass from the top down, removing
no more than 20cm in each pass to prevent
wrapping.
The blade is not cutting
the line.
◾ The line-cutting blade on the
edge of the guard has become
dull.
◾ Sharpen the line-cutting blade with a le or
replace it with a new blade.
Cracks on the trimmer
head or the spool
retainer comes loose
with spool base.
◾ The trimmer head is worn out. ◾ Replace the trimmer head Immediately
performed by a qualied service technician.
During line replace-
ment, the line can’t be
loaded into the trimmer
head properly.
◾ Spool retainer’s LOAD lines do
not align with the eyelets in the
spool base.
◾ Rotate the spool retainer in the arrow direction
to align the LOAD lines on the spool retainer
with the eyelets in the spool base.
◾ The string line is not correctly
inserted into the mounting hole
in the eyelet.
◾ Align the LOAD lines with the eyelets rst, then
insert the line into the mounting hole inside
the eyelet.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.