Installing your Smoke Alarm
(a) Attaching to Ceiling or Wall.
(NB: for wiring the Ei100C Interconnect model see page 9)
The Smoke Alarm is battery operated and needs no wiring,
(Ei100C excepted). Use figure 6 below, as a help in
mounting.
1. Pull Cover open at Tab (2). Remove Cover from Base by
separating at rear Snap-in Hinges (5).
2. Place the Base on ceiling or wall exactly where you want to
mount the unit. With a pencil, mark the location of the Screw
Holes (6)
3. Taking care to avoid any electrical wiring in the ceiling or
wall, drill a hole through the centres of the marked locations.
Push the plastic Screw Anchors provided into-the drilled
holes. Screw in firmly.
(b) Connecting the battery.
With a pencil, write the date of Battery installation on the inside
of the Cover to remind you when to replace the battery (4).
Lift Battery from Battery holder, and snap Battery Connectors
to Battery. They fit together only one way (Figure 7).
Gently push Battery into Battery Holder (9)
To close the cover match up Snap-in Hinges (5) and gently
press together until Base and Cover snap together.
6
To Next Page
Loading...
Need help?
General
