30
MAINTENANCE ACTIVITY CARE:
Before starting the scheduled / preventive maintenance activity, ensure the engine is started and run for
around 15 minutes to confirm the engine starting ability, abnormal noise, vibrations, oil leakage, fuel
leakage, function of electrical instruments and gauges. This will facilitate in better understanding of the
engine before proceeding for the maintenance activity.
ENGINE LUBRICATING OIL REPLACEMENT:
Always perform engine lubricating oil replacement when the engine is in warm condition to ensure complete
draining of lubricating oil from oil sump.
The following steps shall be followed:
Ensure equipment is positioned on flat surface.
Unscrew the oil drain plug and drain the oil in tray.
Install and retighten the Drain Plug.
Ensure to replace the Copper Gasket of the drain plug
with new.
Fill with recommended quantity of EICHER GENUINE
lubricating oil through the Filler Cap.
Allow 10 Minutes to facilitate oil to reach the oil Sump.
Reconfirm the oil level through dip stick after starting
and stopping of the engine. If found less top up to the
level. Ensure sufficient time is allowed as discussed
above before checking the oil level.
CAUTION!
Necessary care shall be taken while working as high
temperature will result in burns.
Do not mix different brands of oil.
Clean the surface thoroughly.
Do not dispose the used oil on the ground as it is
hazardous to environment safety. Always collect, store
and dispose the old used oil in a container and dispose as per safety rules.
Drain Plug
Oil Filler Cap
To Next Page
Loading...
Need help?
General
