EIK AM200 - Page 29

www.eikengineering.com
Figure 2.11
Figure 2.12
2.6.3 Figure 2.12 above illustrate the hydraulic motor case.
(1) Oil level check port
(2) Oil drain port
(3) Oil fills port
2.6.4 The steps for hydraulic motor oil change are:
 Position one of hydraulic motor so that oil drain port (2) is at the bottom as per
figure 2.12.
 Remove all plugs at port (2), (1), and (3). Allow the oil to drain into a suitable
container.
26