Need help?Do you have a question about the EIM 2000 Series and is the answer not in the manual?
General| Product Series | EIM 2000 Series |
|---|---|
| Category | Control Unit |
| Input Voltage | 24 VDC |
| Operating Temperature | -20°C to +60°C |
| Number of Analog Inputs | 4 |
| Number of Analog Outputs | 2 |
| Protection Rating | IP20 |
| Mounting | DIN Rail |
| Communication Interface | Ethernet |
Detailed steps for setting up parameters like analog input/output, delay, and deadband.
How to select operating modes like loss of signal behavior and motor starter type.
Steps to calibrate the 4-20mA analog input signal for position command.
Steps to calibrate the 4-20mA analog output signal for position feedback.
How to enable/disable and set default position on signal loss.
Final calibration step to match feedback to valve travel limits.
To Next Page