EINHELL GC-PM 47 S HW User Manual

GB
- 30 -
7.4 Preparing the mower for transport
Warning! Do not empty the petrol tank in enc-
losed areas, near fi re or when smoking. Petrol
fumes can cause explosions and fi re.
1. Drain the petrol tank using a petrol extraction
pump.
2. Always let the engine run until it has used up
the remainder of petrol in the tank.
3. Empty the engine oil from the warm engine.
4. Remove the spark plug connector from the
spark plug.
5. Clean the cooling fi ns of the cylinder and the
housing.
6. Unhook the starter cable from the hook (Fig.
3b). Slacken the connection shown in Fig. 3a
on the left and right of the push bar and swing
down the push bar (Fig. 14). Make sure that
the actuator cables do not get kinked when
the bar is pulled up.
7. Wedge a few layers of corrugated cardboard
between the upper and lower push bars and
the engine in order to prevent any chafi ng.
8. Secure the load suffi ciently so that it cannot
slip and cause damage or injuries during
transportation.
7.5 Consumables, wear materials and spare
parts
Spare parts, consumables and wear materials
such as engine oil, V-belts, spark plugs, air fi lter
inserts, petrol fi lters, batteries and blades are not
covered by the warranty.
7.6 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
Anl_GC_PM_47_52_56_S_HW_SPK7.indb 30Anl_GC_PM_47_52_56_S_HW_SPK7.indb 30 09.11.2015 13:53:0509.11.2015 13:53:05

EINHELL GC-PM 47 S HW Specifications

General

Type	Walk behind lawn mower
Drive type	Rear wheel drive
Cutting width	470 mm
Product color	Black, Grey, Red
Cutting system	Cylinder blades
Number of wheels	4 wheel(s)
Rotational speed	2850 RPM
Maximum lawn area	1400 m²
Fuel tank capacity	1.2 L
Handle(s) features	Soft grip
Engine displacement	139 cm³
Rear wheels diameter	280 mm
Front wheels diameter	200 mm
Maximum cutting height	70 mm
Minimum cutting height	25 mm
Grass collecting volume	75 L
Engine number of strokes	4
Number of height positions	6
Cutting clearance adjustment	Yes
Power source	Gasoline

Weight and Dimensions

Weight	37700 g
Package depth	460 mm
Package width	600 mm
Package height	910 mm
Package weight	42000 g