EINHELL GE-CM 18/30 Li - Solo - Troubleshooting; Troubleshooting Common Issues

GB
- 33 -
11.
T
roubleshooting
Fault
Possible causes
Remedies
The motor fails to
start
a) The connectors have become se-
parated from the motor
b)
The mower is standing in high
grass
c) The mower housing is clogged
d) Safety switch is not inserted
e)
Battery is not correctly inserted
a) Have repaired by the Customer
Service Center
b)
Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary
c) Clean the housing so that the blade
moves freely
d)
Insert safety switch (see 6.)
e)
Remove the battery and reinsert
(see 5.)
The motor perfor-
mance drops
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
d) Battery performance decrea-
sing
a) Correct the cutting height, change
the electronics setting
b) Clean the housing
c) Replace the blade
d) Check the battery performance
and charge the battery if necessary
(see 5.)
Cutting is irregular
a) The blade is worn
b) Wrong cutting height
a) Replace or resharpen the blade
b) Correct the cutting height
Notice! For protection, the motor is equipped with a therm
al switch which cuts out when the
motor is overloaded and switches on again automatically
after a short cooling period
Anl_SA_GE_CM_18_30_Li_Solo_ARG.indb 33
24.07.2018 09:28:50