GB
- 21 -
7.1 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.2 Changing the garden hose
If the how reel is already fi tted with a hose, fi rst
pull out the hose to the mark.
Fig. 10 a: Remove the two screws from the
maintenance fl ap and then fl ip the maintenance
fl ap from the top to the front. Important! Risk of
pinching - The hose reel is allowed to be operated
only when the maintenance fl ap is fi tted.
Fig. 10 b: Another cover (Item A) should now be
visible in the hose reel. If this is not the case, ca-
refully turn the hose reel to the rear. Remove the
cover by undoing the screw.
Fig. 10 c: Remove the fastening clasp (Item B)
from the quick-lock coupling and then separate
the quick-lock coupling from the hose reel. To be
able to pull the hose out of the hose reel you must
also take the quick-lock coupling off the hose.
Fig. 10 d: To fi t a new hose, proceed in reverse or-
der. First pass the hose without quick-lock coup-
ling through the opening in the hose reel and into
the hose guide. Then feed the hose to the rear
around the hose reel.
Fig. 10 e: The supplied quick-lock coupling can
then be fi tted and the hose can be connected to
the hose reel from underneath. To prevent the
quick-lock coupling from working itself free, it
must be secured with the help of the fastening
clasp.
Fig. 10 f: Finally, the connection cover and the
maintenance fl ap must be refi tted. After the bat-
tery is inserted, the hose can be wound up by
pressing the button.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
•
Store the equipment and accessories in a
dark and dry place at above freezing tem-
perature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in
its original packaging.
•
Before lengthy periods of non-use or winter
storage, rinse the garden hose of the cord-
less hose reel thoroughly with water, empty it
completely and store it in a dry place.
•
The equipment must be completely drained if
there is a risk of frost.
10. Transport
Plug the connection hose on the blind nipple
(Fig. 11/Item 11).
Notice! For protection, the motor is equip-
ped with a thermal switch which cuts out
when the motor is overloaded and switches
on again automatically after a short cooling
period.
Anl_GE_HR_18_30_WH_Li_SPK13.indb 21 27.09.2023 10:27:58
To Next Page
Loading...
