EINHELL GH-KS 2440 - Troubleshooting Guide

GB
- 22 -
10. Troubleshooting guide
Fault Possible cause Remedy
The machine does
not work
- No power at the plug
- Machine is switched off
- Overload switch has tripped
- Ejector chute is blocked
- Loading funnel is not secure on the
motor housing
- Check the power cable and fuse
- Switch on machine
- Press control on overload switch
- Clean ejector chute
- Clean interior and tighten safety
screw
Shredding perfor-
mance unsatisfac-
tory
- Blades worn - Turn, sharpen or replace blades
Anl_GH_KS_2440_SPK7.indb 22Anl_GH_KS_2440_SPK7.indb 22 29.04.13 09:0529.04.13 09:05