EINHELL RASARRO 36/42 - Troubleshooting

EN
- 19 -
10. Troubleshooting
Problem Possible causes Solution
Motor does not start
or comes to a stop
(loose connection).
a) Motor terminals disconnected.
b) The mower is standing in high
grass.
c) The mower housing is clogged.
d) Safety plug is not inserted.
e) Battery is not correctly inserted.
f) Insuffi cient or no contact between.
the handle and the handle fastener
(Fig. 3 / Section 5).
a) Have repaired by service center.
b) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary.
c) Clean the housing so that the blade
moves freely.
d) Insert safety plug (see 6).
e) Remove the battery and reinsert
(see 5).
f) Undo the handle connection, check
the contacts for dirt and carefully
clean with a brush. Tighten the
handle connection (see 5).
The motor
performance drops.
a) The grass is too high or too damp.
b) The mower housing is clogged.
c) The blade is severely worn.
d) Battery performance
decreasing.
a) Correct the cutting height.
b) Clean the housing.
c) Replace the blade.
d) Check the battery performance-
and charge the battery if necessary
(see 5).
Cutting is irregular. a) The blade is worn.
b) Wrong cutting height.
a) Replace or re-sharpen the blade.
b) Correct the cutting height.
Notice! For protection, the motor is equipped with a thermal switch which cuts out when the
motor is overloaded and switches on again automatically after a short cooling period.
Anl_Rasarro_36_42_SPK7_USA.indb 19Anl_Rasarro_36_42_SPK7_USA.indb 19 15.12.2022 08:52:2415.12.2022 08:52:24