EasyManua.ls Logo

EINHELL STE 3500 - Troubleshooting

EINHELL STE 3500
40 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB
11
15. Troubleshooting
Fault
Engine does not start
Generator has too little or no
voltage
Cause
Automatic oil cut-out has not res-
ponded
No fuel
Controller or capacitor defective
Overcurrent circuit-breaker has
triggered
Air filter dirty
Remedy
Check the oil level, top up with
engine oil
Refuel
Contact your dealer
Actuate the circuit-breaker and
reduce the consumers
Clean or replace the filter
Anleitung STE 3500 SPK1 28.09.2005 15:08 Uhr Seite 11

Related product manuals