EINHELL TC-GW 190 D - User Manual

Questions and Answers

A
Amy GordonAug 10, 2025
What to do if the feed roller turns but doesn't feed wire on my EINHELL Welding System?
- O
  owenlindseyAug 11, 2025
  If the feed roller is turning but no wire is being fed in your EINHELL Welding System, consider these possibilities: * Incorrect roller pressure: Check the setting. * Roller brake set too firmly: Check the setting. * Dirty or damaged feed roller: Clean or replace it. * Damaged hose package: Check the wire guide jacket. * Contact tube wrong size, dirty, or worn: Clean or replace it. * Welding wire welded to the gas nozzle or contact tube: Release it.
L
Lisa RobinsonAug 19, 2025
Why is the weld so poor on my EINHELL TC-GW 190 D Welding System?
- S
  Susan CooperAug 19, 2025
  If you're getting very poor welds with your EINHELL Welding System, the issue could stem from incorrect current or feed settings. Make sure to check these settings. Another potential cause is insufficient or no gas flow. Verify the gas settings and the filling pressure of your gas bottle.
D
David BradfordAug 26, 2025
How to fix a feed roller that won't turn on an EINHELL TC-GW 190 D?
- K
  Kimberly SandersAug 26, 2025
  If the feed roller isn't turning on your EINHELL Welding System, it could be due to a disconnected power supply. Ensure the connection is secure. Alternatively, the wire feed controller might be set to 0. Double-check that setting.
J
jamesreedSep 2, 2025
What to do if EINHELL Welding System overheats and stops working?
- C
  Christopher MillerSep 2, 2025
  If your EINHELL Welding System stops working after extended use and the thermostat control light is on, it likely overheated because it was used for too long without allowing sufficient cooling time. Let the unit cool down for at least 20 to 30 minutes.

EINHELL TC-GW 190 D Specifications

General

Welding current	25 - 160 A
Wire spool weight max.	5 kg
Protection class	IP21S
Mains supply	230 V
Wire diameter	0.6 / 0.8 mm
Diameter welding wire	0.6 / 0.8 mm
Duty cycle	10% at 160 A
Electrode diameter	1.6 mm