DANGER!
Read all the safety information and instructions. Failure to adhere to the safety information and instructions set out
below may result in electric shock, fi re, and/or serious injury. Keep all the safety information and instructions in a
safe place for future use. Special information about the laser
Caution: Laser radiation Do not look into the beam Laser class II
Complies with 21 CFR 1040.10 and 1040.11 except for deviations
pursuant to Laser Notice No.50, dated June 24/2007
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces or persons or animals. Even a low output laser beam can
inflict injury on the eye.
Caution: Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
Never open the laser module.
It is prohibited to carry out any modifications to the laser to increase its power.
The manufacturer cannot accept any liability for damage due to the non-observance of the safety information.
Safety information on the batteries
Use of the batteries
Inserting the batteries when the laser is switched on can cause accidents.
If the equipment is not used correctly, the batteries may leak. Avoid contact with the battery fluid. If you come
into contact with battery fluid, clean the affected body part with running water. If you get battery fluid in your
eyes, seek immediate medical assistance.
Escaped battery fluid can cause skin irritation and acid burns.
Never expose the batteries to excessive heat such as sunshine, fire, or similar.
Never recharge batteries that are not suitable for recharging. There is a risk of explosion!
Keep batteries away from children, do not short circuit batteries or disassemble.
Seek a doctor’s advice immediately if a battery is swallowed.
If necessary, clean the contacts on the battery and equipment before inserting the batteries.
Ensure that you insert the batteries the right way round.
Remove flat batteries immediately from the equipment. There is an increased risk of leakage.
Always change all batteries in one go.
Insert only batteries of the same type, do not use different types of batteries or used and new batteries
together.
Make sure that the equipment is switched off after use.
Remove the batteries if the equipment is not used over a longer period.
Keep this safety information in a safe place.
Layout and items supplied
Layout (Fig. 1-3)
1. On/Off switch (blocking the laser)
2. Horizontal laser
3. Vertical laser
4. LED display
5. Laser line selector button
6. Battery compartment cover
To Next Page
Loading...
