EINHELL TC-US 380 User Manual

GB
- 23 -
be sanded with the grain to prevent them
splitting.
Caution!
If the grinding/sanding disk or the grinding/san-
ding belt becomes jammed during operation, re-
move the workpiece and wait until the equipment
reaches its top speed again. You may have to
guide the workpiece towards the grinding/sanding
disk or grinding/sanding belt with less force.
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8.4 Transport
Transport the machine by lifting it by the base
plate (9) only. Never use the safety devices for
handling or transporting purposes.
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
Anl_TC_US_380_SPK9.indb 23Anl_TC_US_380_SPK9.indb 23 19.10.2021 15:42:3619.10.2021 15:42:36

EINHELL TC-US 380 Specifications

General

Product type	Belt/disc sander
Grain sanding	P80
Mounting type	Bench-top
Adjustable angle	Yes
Sanding belt width	100 mm
Sanding belt length	914 mm
AC input voltage	230 - 240 V
AC input frequency	50 Hz

Weight and Dimensions

Weight	13250 g
Package depth	503 mm
Package width	269 mm
Package height	312 mm
Package weight	14590 g