GB
- 7 -
4. Technical data
Motor power supply: ............................... 18 V DC
Idling speed: .....................................0-2300 min
-1
Blow rate: .........................................0-2900 min
-1
Clockwise/counter-clockwise: ........................Yes
Bit mount: ................................... 1/4 “ (6.35 mm)
Battery charger output voltage: .............. 21 V DC
Battery charger output current: ....................... 3 A
Charging unit supply
voltage: ............................. 200-250 V~ 50-60 Hz
Battery type: ...................................... Lithium-ion
Number of battery cells: ................................... 5
Battery capacitance: ................................. 2.0 Ah
Weight: .......................................................1.4 kg
Max. screw diameter: ................................. 8 mm
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
L
pA
sound pressure level ................... 77,19 dB(A)
K
pA
uncertainty ............................................. 3 dB
L
WA
sound power level ..................... 88,19 dB(A)
K
WA
uncertainty ............................................. 3 dB
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Screwing without hammer action
Vibration emission value a
h
= 1.089 m/s
2
K uncertainty = 1.5 m/s
2
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment’s construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
Limit the operating time.
All stages of the operating cycle must be conside-
red (for example, times in which the electric tools
are switched off and times in which the tool is
switched on but operates without load).
Caution!
The metal gear head may become hot during pro-
longed operation.
5. Before starting the equipment
Be sure to read the following information before
you put the cordless screwdriver into operation:
1. Charge the battery pack with the charger sup-
plied.
2. Only ever use screwdriver bits which are
suitable for the purpose and in faultless con-
dition.
Anl_TE_CI_18_1_Li_4257239_SPK7.indb 7Anl_TE_CI_18_1_Li_4257239_SPK7.indb 7 13.12.2023 10:05:5713.12.2023 10:05:57
To Next Page
Loading...
Need help?
General
Weight and Dimensions
