Why is there no spark when I depress the gas control knob on my Eisno HB4801?
If there's no spark when you depress the gas control knob, it could be due to a few reasons. First, ensure the hob is properly plugged in and switched on, and check your mains circuit breaker. Another potential cause is that the burner isn't aligned properly; try removing and refitting the burner.
What to do if the burner on my Eisno HB4801 Hob isn't lighting even though the spark ignition is working?
If the spark ignition is working, but the burner isn't lighting, there are a few things you can check. Make sure the gas supply valve is turned on. Also, the burner may not be aligned properly, so try removing and refitting it. Finally, the burner ports could be blocked. In this case, remove, clean, and replace the burner.
Why does the burner on my Eisno HB4801 go out when I release the control knob?
If the burner goes out when you release the control knob, it could be that the flame safeguard isn't activated. Try re-lighting the burner and allow more time for the flame safeguard to activate.
Why is the flame on my Eisno Hob so small even on the High setting?
The small flame on a High setting can be caused by using an incorrect utensil size. Refer to the operating instructions for proper utensil choice.
Why is the flame too high on the High setting on my Eisno HB4801 Hob?
The flame being too high on the High setting can be caused by using an incorrect utensil size. Refer to the operating instructions for proper utensil choice.
How to fix an uneven flame pattern or slight flame lifting on my Eisno HB4801?
An uneven flame pattern or slight flame lifting is usually caused by blocked burner ports. Remove, clean, and then replace the burner to resolve this.
General| Fuel Type | Gas |
|---|---|
| Number of Burners | 4 |
| Hob type | Gas Hob |
| Material | Stainless Steel |
| Ignition Type | Automatic |
| Gas Type | LPG/NG |
| Weight | 8 kg |
To Next Page