EIT Part Number: P/N IM-0110 Rev A Issued April 2019
Page 14
Appendix D Technical Support, MicroCure Disposal and Warranty
Technical Support
Technical support is available through EIT or one of our authorized representatives or distributors
EIT may be reached via email (uv@eit.com) or phone (703-478-0700)
A list of representatives and distributors can be found on our web site: https://www.eit.com/products/representatives-
and-distributors
MicroCure Disposal
MicroCure units are RoHS compliant and should be properly recycled. Units may be returned to EIT for proper disposal.
There is no charge for this service if the MicroCure units are sent prepaid to EIT. Please return units to:
Electronic Instrumentation and Technology (EIT) LLC
Attention: EIT Instrument Markets
309 Kelly’s Ford Plaza SE
Leesburg, VA 20175 USA
Warranty
The MicroCure
®
radiometer is given a one-time calibration before it is shipped from EIT. The MicroCure is designed for
200 readings or one year, whichever comes first. Once the MicroCure reaches the first one of either of these two
conditions, the EIT warranty is void on the MicroCure and the unit must be replaced. Please refer to the Handling and
Safety Precautions stated earlier in this manual.
EIT warrants that all goods described in this manual shall be free from defects in material and workmanship. Such defects
must become apparent within six months after delivery of the goods to the buyer.
Any suspected warranty claim for MicroCure must be reported prior to the maximum reading limit of 200 readings.
EIT’s liability under this warranty is limited to replacing or repairing the defective goods at our option. EIT shall provide all
materials and labor required to adjust, repair, and/or replace the defective goods at no cost to the buyer only if the defective
goods are returned, freight prepaid, to EIT Instrument Markets during the warranty period.
EIT shall be relieved of all obligations and liability under this warranty if:
1. The user operates the device with any accessory, equipment, or part not specifically approved, manufactured, or
specified by EIT, unless the buyer furnishes reasonable evidence that such installations were not a cause of the defect.
This provision shall not apply to any accessory, equipment, or part that does not affect the proper operation of the device.
2. Upon inspection, the goods show evidence of becoming defective or inoperable due to abuse, mishandling, misuse,
accident, alteration, negligence, improper installation, lack of routine maintenance, or other causes beyond our control.
3. The goods have been repaired, altered, or modified by anyone other than EIT authorized personnel. MicroCure
radiometers are only sold and serviced at EIT and not through any of our authorized service centers.
4. The buyer does not return the defective goods, freight prepaid, to EIT within the applicable warranty period.
There are no warranties that extend beyond the description on the face hereof. This warranty is in lieu of-and is exclusive
of-any and all other expressed, implied, or statutory warranties or representations. This exclusion includes merchantability
and fitness, as well as any and all other obligations or liabilities of EIT.
EIT shall not be responsible for consequential damages resulting from malfunctions of the goods described in this manual.
To Next Page
Loading...