EIT Part Number: P/N IM-0110 Rev A Issued April 2019
Page 15
No person, firm, or corporation is authorized to assume for EIT, any additional obligation or liability not expressly provided
for herein except in writing duly executed by an officer of EIT.
If any portion of this agreement is invalidated, the remainder of the agreement shall remain in full force and effect.
This warranty shall not apply to any instrument or component not manufactured by EIT.
Returning a MicroCure and/or DataReader to EIT
An RMA is not required but each unit should be returned with a Service Request Form that can be found at:
https://www.eit.com/products/customer-service-support
Please return the equipment in the original (or equivalent) packaging. You will be responsible for damage incurred from
inadequate packaging, if the original packaging is not used. The customer is responsible for insuring the unit during
transportation to EIT.
Once received, EIT will determine if the issue will be covered under warranty or of the issue is a non-warranty issue
Equipment covered under warranty will be returned to the user with no charge for the repair or shipping.
EIT notify you of any repairs not covered by warranty and their cost prior to performing any work on the equipment.
Ship the unit, freight prepaid, to the address below:
Electronic Instrumentation and Technology (EIT) LLC
Attention: EIT Instrument Markets
309 Kelly’s Ford Plaza SE
Leesburg, VA 20175 USA
Include the Service Request Form which should state Company Name, Address, Telephone Number and Email
address. We will contact you if any additional information is needed.
EIT Instrument Markets reserves the right to make changes in design at any time without incurring any obligation to
install the same on units previously purchased.
To Previous Page
Loading...
