Measurement operation
User Manual Biosen C_line Clinic / GP+
7. Measurement operation
7.1 Readiness for measurement
This display window is the ready window of the device. From here all
device functions are accessible.
Figure 20 - Ready to measure
The status text describes the current state of the device (e.g. ready, in
calibration, Stand By).
The message "with calibration" can vary depending on the
selected calibration mode (see section 9.3, page 33).
The advice text is used to display messages if required (e.g.
surrounding temperature too high). This field is normally empty.
7.1.1 Measurement control mode
The measurement control mode is possible only if there is a
measurement card (prepaid-card).
Information about the stock of the system solution and / or the detection
of containers for detection on the map of measurements in electronic
form. Thus, the measurement of the parameters of the entire system to
provide a map of qualitative analysis. Rent measurement cards (prepaid-
cards) to the universal appliance via serial number. On sale there are
cards (prepaid-cards) for a different number of measurements. The
number of measurements is indicated in the Ready information box as
additional text.
To Next Page
Loading...
Need help?
General
