EKKO EB18E - Page 18

17
Maintenance interval ●
W A B C
Brake
1.1 Check the air gap of the electromagnetic brake ●
Electric
system
2.1 Check the function of operation switch, display equipment
and component
●
2.2 Check alarm systems and safety devices ●
2.3 Check the cable for damage. Whether the terminal is firm.
●
2.4 Check the function of micro switch setting ●
2.5 Check the controller and the EPS controller
●
2.6 Cable and motor fixation ●
Power
3.1 Check battery
●
3.2 Check the charging connector for battery ●
3.3 Check whether the connection of the battery cable is tight,
and smear the electrode with grease if necessary
●
Driving
system
4.1 Check the gearbox for noise
●
4.2 Check the driving mechanism and grease, check the reset
function of the operating handle
●
4.3 Check the drive wheels and bearing wheel for wear and
damage
●
4.4 Check wheel bearings and fixtures ●
Massive
structure
5.1 Check the frame for damage
●
5.2 Check the label for completeness ●
5.3 Check the fixation status of lifting mast ●
The
hydraulic
system
6.1 Check the hydraulic system function
●
6.2 Check that hoses, pipes, and joints are tight and that seals
are not damaged
●
6.3 Check cylinder and piston for damage, seal and fixation
●
6.4 Check load chain Settings and re-tighten if necessary ●
6.5 Visually inspect mast roller and inspect roller surface for
wear
●
6.6 Inspect cargo fork and load parts for wear
●
6.7 Check oil level ●
6.8 Renewed hydraulic oil
●
Maintenance