EKKO EB20E - 1. Maintain List; a. Main part overview

1
1. Maintain List
a. Main part overview
Table 1 : Maintain List
Time Interval
（Month）
1 3 6 12
Hydraulic System
1
Check hydraulic cylinder and piston for damage, noise and leakage.
•
2
Check hydraulic connector for damage and leakage.
•
3
Check hydraulic oil level and refill it if necessary.
•
4
Refill hydraulic oil after 12 months or 1500 hours.
•
5
Check and adjust the function of the hydraulic value. (1500kg/2000kg +0/+10%)
•
Mechanical System
6
Check whether the fork is deformed or broken.
•
7
Check whether the chassis is deformed or broken.
•
8
Check whether all screws are fastened.
•
9
Check whether the push rod is deformed or damaged.
•
10
Check the gearbox for noise and leakage.
•
11
Check whether the wheel rod is deformed or damaged.
•
12
Lubricate steering bearings
•
13
Check and lubricate the pivot point.
•
14
Grease nipple
•
Electrical system
15
Check whether the power wiring is damaged.
•
16
Check the electrical connection
•
17
Check the emergency switch function.
•
18
Check electric rive system for noise damage.
•
19
Check electricity meter.
•
20
Check whether the correct fuse is used.
•
21
Detection warning signals.
•
22
Check the contactor
•
23
Check the leak in the frame(insulation test)
•
24
Check the function and wear of the drive controller
•
25
Check the electric system of the drive motor.
•
Brake system
26
Check the brake performance. Replace the brake disc or adjust the air gap if necessary.
•
Battery
27
Check the battery voltage.
•
28
Check the terminal for corrosion and damage and lubricate the terminal.
•
29
Check whether the battery cover is damaged.
•
Charger
30
Check whether the main cable is damaged.
•
31
Check startup protection program in the process of charging.
•