EKO MP-11 - Page 14

EKO INSTRUMENTS CO., LTD. I-V Curve Checker MP-11 Instruction Manual Ver.7
Pg. 13
Table 5-1. Parts Name and Function -- Main Unit
Parts Name
Details
1
Main Unit Cover
All components, such as the sensor unit and the cables, can be stored inside
the main unit.
The cover can be removed by sliding the lid to the right side as it is opened.
2
Cushion Pad for Sensor
Unit Dome
Hold and protects the sensor unit dome inside the main unit.
3
Rear Panel
The connections for PV jacks (+/-), module jack, DC jack for the Battery
Receptacle Box are on the rear panel.
4
LDC Display
Displays the operation menu and measurement results.
5
Key Board
Operations, such entering parameters and starting measurements, are done
from this key board.
6
Modular Jacks
Used for the communication between the main unit and the sensor unit.
7
PV connector
There plus (+) and minus (-) jacks.
8
Power Supply Jack
Connect either AC adaptor or Battery Receptacle Box.
9
Earth Terminal
Connect ground for safety.
10
Storage Space
Sensor unit and the cables are stored in this space.
11
USB Port
Used for downloading/uploading the data to and from the PC.
12
Latch
Push this latch button to and lift the cover to open the Main unit cover.
13
Case Handle
Insert your fingers here for carrying the main unit.
14
Strap Hooks
Shoulder straps are attached to these hooks.