EKO MP-11 - MP-11 Operation; MP-11 Key Operation

EKO INSTRUMENTS CO., LTD. I-V Curve Checker MP-11 Instruction Manual Ver.7
Pg. 36
8. MP-11 Operation
8-1. MP-11 Key Operation
Table 8-1. MP-11 Operation Panel Buttons
Buttons
Functions
POWER Button
Turns ON the power by pushing the button
Turns OFF by holding down on the button for 5sec.
DATA Button
Function key that is related to displaying the measured data.
CONFIG Button
Function key that is related to measurement setup.
MEASURE Button
Function key that starts the measurement (starts immediately when it is pressed)
Up/ Down Buttons
Used when selecting menus.
It becomes Monitor function when pressed on Main Menu Display.
Left/Right Buttons
Used when selecting parameters and moving the zoomed up display screen.
ENTER Button
Used when going forward with the process and determining to input.
Esc Button
Used when returning to the previous display and terminating a process
Numerical Buttons
Used as numbers, as well as in the manner of table below by pressing multiple times.
[+/-] key is used in I-V curve graph display for changing the scales of the display as x2, x4,
and x8.
#
Functions
#
Functions
1
1, A, B, C
7
7, S, T, U
2
2, D, E, F
8
8, V, W, X
3
3, G, H, I
9
9, Y, Z, @
4
4, J, K, L
0
0, /, *, #
5
5, M, N, O
.
. , [SPACE]
6
6, P, Q, R
+/-
+/-, &
Figure 8-1. Operation Panel
POWER Button
DATA Button
CONFIG Button
MEASURE Button
Left/Right Buttons
Enter Button (Enter)
Escape Button (Esc)
Up/Down Buttons
Numerical Buttons